Frequently Asked Questions
Find answers to common questions about JVL motors, protocols, software, and accessories. Use the search bar or browse by category.
Showing 64 of 64 articles
General Questions
030202 How to set up RxPDO 24 when using FCx.
Absolute Encoder in MAC400/800
Are there default values for each motor type ?
Can an external encoders be connected ?
Can modules be mounted outside the MAC motors ?
Color code of the internal connections in the MIS23x.
Courses
Fan always blowing ( Reg. 39 )
FAQ - Hollow Rotary Actuator / Table
Firmware versions and dip-switches
Functions in SMC85 ( MIS34, MIS43 and MIS53 )
Gear mode is missing when making a program ?
Getting started
Guide to teams
How are Velocity and Acceleration scaled?
How do I change Actual Position register value ?
How do I change Actual Position register value ?
How do I control posion using AIN ?
How do I get the newest MacTalk version ?
How do I make a program for a limit switch ?
How do I run to absolute or relative positions ?
How do I save or get an EEPROM value in the module ?
How do I scale MAC800 Velocity, Acceleration/deceleration and position?
How do I setup the Filter Parameters and what is the Load Factor ?
How do I stop the MAC motor in the middle of a move ?
How do I stop the MAC motor in the middle of running ?
How do I update the firmware in the motor and the module ?
How does Group Id work with SMC75 ?
How does Torque Homing work ?
How is AIN connected internally in MAC00-B1 ?
How is the serial communication to the MAC motors ?
In which register can I find the Actual Torque ?
In which register can I find the Actual Torque ?
Inrush current for MAC140-A1 + B4 module ?
Is absolute encoder available together with SMC75
Is Autotuning available ?
Is it possible to communicate through Hyperterminal ?
Is the index pulse available at the IO connector ?
MAC00-FCx PDO communication with Beckhoff FC51xx.
New Reg. 39 bits
OCX and different Windows versions.
Program for MAC140 to extend logical position range.
RS485
Strange jumps when using "Sensor Zero Search"
Strange jumps when using "Sensor Zero Search".
Support
Syncronize Position Registers Inside an RxP Program
Test tab runs incremental and not absolute as expected ?
There are 4 accelerations, 4 torques, 4 Load Factors. How are they applied to 8 position registers ?
To which of the 8 available position registers do the “In Position Windows” apply?
Update firmware from 1.35 and up.
What are Reg. 35 bit 18,19 and 20 used for ?
What communication speed is possible?
What does "Resyncronize position after passive mode" mean and do?
What is "Function error" ?
What is "In Position Window" and "In Position Counts" ?
What is O1 used for ?
What is O2 used for ?
What is the "Home Position” ?
Which input is used for "Zero search " ?
Which types exist today ?
Which types of MAC400/800 exist today ?
Which values for Load factor can be used with succes ?
Why do you call it an AC Brushless motor and not a DC Brushless ?
Can't Find What You're Looking For?
Our engineers are ready to help with your specific questions.
Contact SupportRequest a Quote